Pics + Video

Ben in LA has an aluminum flat bottom jon boat.  While boating with his wife, he came to a patch of shallow water that caused his boat to come to an abrupt halt, almost tossing himself and his wife out out into the river.  He ordered some Wetlander, put it on his hull, then he sent us this video…

Ben went back to the same stretch of skinny water that had stopped him dead in his tracks before.  His words: “I almost killed me and my wife before I coated it… Went back and slid over it like it was nothing… Thanks for the good stuff… Saved my marriage… Ha”.

Chuck and the team at Widowmaker in UT has been using Wetlander on his custom boat builds for years.  Bowhunting for invasive carp is big fun out there, and Widowmaker Boats are the key…

Joe and family at Koffler Boats in the Pacific Northwest make high quality aluminum drift boats, prams and power boats. They use Wetlander on their custom aluminum builds.


James in KY sent us this vid with the subject line “Thanks for a great product!”.  Glad you like it James.

Another from James in KY

Wanna see how Wetlander stacks up one of the other hull coatings out there?


8 Comments on “Pics + Video

  1. Have always unhooked boat launching at boat ramps. Backing down the newly coated1652 roughneck hull and the boat slid right off the trailer prior to the water. Good thing it was an outboard jet and not a prop. A big dose of surprise. No damage done other than a little swallowed pride. Stuff is slicker than snot.

  2. See my video about Wetlander, should answer a lot of questions:

    I’ve had the coating for over a year and it’s held up very well. After applying Wetlander be sure and hang on to your boat, it will slide down a hill faster than a fat kid chasing an ice cream truck.

  3. Can the viscosity of the primer and paint be adjusted using water for spraying?

    • Kenneth,

      Yes, it can be thinned by adding up to 5% clean drinking water. I advise against that though… Most spray set-ups that can push latex house paint will be able to shoot Wetlander, both Primer and Topcoat, without thinning. A 3.0 tip works the best.


Leave a Reply

%d bloggers like this: